DMS Seals New spring energized seals manufacturers for aviation

Company Advantages
1. DMS Seals presents a perfect marketing effect with its appealing design style. Its design comes out from our designers who have put their efforts on the innovation of design day-and-night. High-end talents and advanced technology have enabled DMS o-ring seal quality to reach the industry's leading level
2. The extremely soft and comforting surface finish of this product gives sensitive skin a powerful sense of well-being. The high pressure seals have strong wear resistance to hard conditions
3. This product is tested by our quality controllers to assure its high performance at clients. DMS Seals implements and optimizes its quality control systems

1. Application and properties

Suitable for reciprocating piston rod or piston single acting seal, the working pressure has a wide range of adaptability, and the pressure capacity can be enhanced by increasing the tail length size or increasing the check ring.

Small friction coefficient, The contact pressure between the mating surface and the mating surface is low, and the friction between the work face and the mating surface is the smallest in all seal types. with or without lubrication can work, wear resistance, long service life.

The working medium of the sealing sleeve has wide adaptability, and the other chemicals are not reacted except soluble alkali metal, high temperature fluorine gas and three fluoride chloride.

The working temperature range is wide, and can be used for -200 ℃ to +250 ℃.

It can be used for very high speed, very low speed, micro-stroke and other special conditions.

Suitable for aviation, military and industrial sealing groove size, The standard installation groove is the same size as the standard O ring, and the size is small. It can be designed as non standard parts to meet the sealing requirements of any size groove. The groove is open or semi open.

It can be used in rotary sealing. It can adapt to large eccentricity and beating.

2. Standard materials

Sealing sleeve: PTFE

Spring: Stainless steel 304, 316

3. Working Conditions

4. Installation Sizes

Back pressure surfaceR1=0.1 ~ 0.2, tank bottom R2=0.3 ~ 0.5, Import lengthC=(0.7 ~ 1.0)L.

5. Matters needing attention  

Ⅰ, The installation groove must be open or semi open, and it is recommended to be open.

Ⅱ, If the seal is for the rotating shaft, it is recommended that the surface hardness of the shaft should be no less than HRC40.

Ⅲ，Considering the adaptability of the working medium, the adaptability of the jacket and spring should be taken into account.

Ⅳ, It is better to install an anti fouling ring or a antifouling guide ring in the notch direction in front of the seal.

 

Company Features
1. Staff working in Dms Seals Technology Co.,limited are all well-trained.
2. To implement sustainability, we constantly seek new and innovative solutions to minimize the ecological impact of our products and processes during production.