DMS SEALS TECHNOLOGY CO.,LIMITED
DMS Seals-Mechanical Seals and Oil Ring Seals Manufacturer
The Professional Sealing Solution Supplier(O Ring Suppliers & Oil Seal Manufacturers).
1. Application and properties
Suitable for reciprocating piston rod or piston single acting seal, the working pressure has a wide range of adaptability, and the pressure capacity can be enhanced by increasing the tail length size or increasing the check ring.
Small friction coefficient, The contact pressure between the mating surface and the mating surface is low, and the friction between the work face and the mating surface is the smallest in all seal types. with or without lubrication can work, wear resistance, long service life.
The working medium of the sealing sleeve has wide adaptability, and the other chemicals are not reacted except soluble alkali metal, high temperature fluorine gas and three fluoride chloride.
The working temperature range is wide, and can be used for -200 ℃ to +250 ℃.
It can be used for very high speed, very low speed, micro-stroke and other special conditions.
Suitable for aviation, military and industrial sealing groove size, The standard installation groove is the same size as the standard O ring, and the size is small. It can be designed as non standard parts to meet the sealing requirements of any size groove. The groove is open or semi open.
It can be used in rotary sealing. It can adapt to large eccentricity and beating.
2. Standard materials
Sealing sleeve: PTFE
Spring: Stainless steel 304, 316
3. Working Conditions
Temperature Range ℃
3 - 1600mm
0 - 20MPa
-200 ~ +250
High and low temperature oil and water and other fluids.
4. Installation Sizes
Back pressure surfaceR1=0.1 ~ 0.2, tank bottom R2=0.3 ~ 0.5, Import lengthC=(0.7 ~ 1.0)L.
2 ~ 10
10 ~ 22
22 ~ 52
48 ~ 150
150 ~ 400
5. Matters needing attention
Ⅰ, The installation groove must be open or semi open, and it is recommended to be open.
Ⅱ, If the seal is for the rotating shaft, it is recommended that the surface hardness of the shaft should be no less than HRC40.
Ⅲ，Considering the adaptability of the working medium, the adaptability of the jacket and spring should be taken into account.
Ⅳ, It is better to install an anti fouling ring or a antifouling guide ring in the notch direction in front of the seal.
DMS Seal Manufacturer spring energized seals supplier for reciprocating piston rod or piston single acting seal
spring energized seals
Hello, please leave your name and email here before chat online so that we won't miss your message and contact you smoothly.